If temperatures tend to freeze in your area, be sure to protect your pipes. Insulate both hot and cold water pipes using heat tape or pipe sleeves available in your home improvement store. If you have water supply lines in your garage, keep the garage door closed as often as possible. Open kitchen and bathroom cabinet doors to allow warmer air to circulate. If you plan to spend some time away from your home, leave the heat on and set your thermostat to at least 55 degrees. You can’t control the weather, but you can put up a good fight to save your pipes.
Melting Ice & Snow: With spring comes nicer weather, but also the occasional risk of flooding in areas that cannot fully absorb all the water. When temperatures fluctuate from day to day, melted ice can refreeze and cause a whole other set of problems. Due to this hazard, it is extremely important to keep an eye on the weather and fix the problem as soon as it occurs.
Water damage is one of the most common causes of home insurance claims. According to ISO, Water damage claims are the second largest frequent insurance claim, following wind and hail damage. The percentage of claims due to water damage is also increasing, while other causes of damage have stayed fairly consistent or even decreased. It's no wonder people have a lot of questions about water damage and what is covered on home insurance, and why things, like "gradual damage" are not covered. Things get even more complicated when we look at the exceptions.
The information in this publication is current as of the revision date. Changes in laws and agency administrative rules made after the revision date may affect the content. View current information on our website. TDI distributes this publication for educational purposes only. This publication is not an endorsement by TDI of any service, product, or company.
This information is not intended as an offer to sell, or the solicitation of an offer to buy, a franchise. It is for information purposes only. Currently, the following states regulate the offer and sale of franchises: California, Hawaii, Illinois, Indiana, Maryland, Michigan, Minnesota, New York, North Dakota, Oregon, Rhode Island, South Dakota, Virginia, Washington, and Wisconsin. If you are a resident of or want to locate a franchise in one of these states, we will not offer you a franchise unless and until we have complied with applicable pre-sale registration and disclosure requirements in your state.
Our water damage technicians first determine the cause of flooding in your home before beginning the process of draining, cleaning, and restoring. The water damage cause plays a vital role in the water damage process. When flooding is caused by natural calamities, there’s a higher chance of bacteria buildup in the affected areas and calls for immediate disinfection. Other water damage causes do not pose health threats and require only the basic process of restoration.
Once our restoration team removes the moisture from your home or business, we then will begin repairing and restoring the property. The length of this process depends on the extent of damage. Our team of trained technicians uses all the latest technology and top industrial equipment to remove the moisture and prevent further damage. The sooner that we are contacted, the less damage can affect your property. We offer emergency services and can arrive at your home or business almost immediately. Call Mr. Restore in Dallas today for a free evaluation of the services we provide.
Our flood damage repair experts have the necessary training and equipment to properly remove flood water and sewage that may contain harmful bacteria and fecal matter. We are available 24 hours a day, 7 days a week to react quickly to flood damage emergencies and help mitigate the damage before beginning the restoration process. Our specific flood damage restoration services include:
If you can already see it, you usually do NOT need to spend money on pre-testing mold. Plain and simple: you just need to remove it. Since no visible mold growth belongs in a healthy home (no matter what the type) and all mold should be removed the same way, there is usually no need to identify what types and concentrations of mold you have via testing.
Though a competent DIY homeowner may be able to clean up and repair some damage, it's important to have a professional assess it first to determine the extent and any underlying conditions. Missing even a small amount, or its causes, can lead to costlier repairs later. Even small quantities of moisture may result in mold growth. Plus, undiagnosed causes will lead to recurrences. For instance, fixing a damaged ceiling but not the leaky roof that caused it will only lead to another wrecked ceiling.
When left to sit for long periods of time, especially if the homeowners temporarily relocate while recovering from a house fire, further structural damage can complicate matters—making it difficult to return life back to normal. Calling in a water damage repair company is an excellent preventative measure for reducing the risk of further problems and headaches.
It’s important to understand the differences because Category 2 and Category 3 water present health risks to your employees and customers and need to be handled differently. The most likely sources of clean water would be water from a pipe, water heater, steam lines or even rainwater. The basic rule of thumb is that it should look and smell like tap water.
Mold can develop within 24 to 48 hours of a flood, says Ashley Small of FEMA, so remove wet contents, including carpeting and bedding, as soon as possible. If an item has been wet for less than 48 hours, it may be salvageable. However, you’ll need to decide whether it holds enough monetary or sentimental value to try to do so. And notify your insurance company before removing items to ensure that you’re not affecting coverage. Always photograph the flood-soaked items.
In the event of water damage, Mr. Restore is the company to call in Dallas. Not only do we offer 24/7 emergency services, but we are also on site within the hour. Our complete restoration services include advanced drying technologies. Our project managers are certified through the American Drying Institute and can ensure that the damage is little to none. We are family owned and operated in Dallas and offer free evaluations to those who contact us for restoration service or environmental remediation. We pride ourselves on being a total restoration and cleanup company. We handle all of our projects in with the highest level of expertise and experience.
Part of drying a house and cleaning it is knowing what you are doing, not learning on the job. Our team is local, understands the soil and water tables of Virginia, but using national standards. We’ve got thousands of happy customers in Northern Virginia, Maryland, and Washington DC, and if you look through our testimonials we probably have one from your town. We’re a hometown team, so your neighbors are our neighbors.
We offer mold prevention services, as any place in your home that has constant moisture is susceptible to mold growth. Mold is often detected by smell, but the problem of mold goes far beyond the odor it creates. Mold creates an unhealthy environment, and many people have severe allergic reactions when they are in the presence of mold or mildew. Any mold that is in your home now must be completely eliminated. More importantly, we can also remove the source of the moisture that allows the mold to begin thriving in the first place. It does no good to get rid of the mold if the conditions remain that allow it to grow again. We can do a thorough assessment of your home and advise you on the best course of action.
Though not the most common precipitator of water damage repair in the NH, storm flooding can cause serious short term and long-term problems to your residential or commercial property. The likelihood of flood-water damage to your property is rising, and property owners need to be prepared to deal with this very real possibility. Flooding from seasonal storms is more common than you’d think, and the problems that arise from it need to be addressed as quickly as possible.
The methods for dealing with damage to walls depend on the type of materials and also what’s behind those materials. Drywall can often be salvaged, when you respond quickly to damage. You can purchase moisture meters that allow you to assess structural integrity. If the integrity checks out then your drying approach will depend on wall contents. If the wall has insulation, you will need to use flood cuts. If there is no insulation, then usually the best method is to create weep holes. And if you’re dealing with a firewall, you’ll want to use staggered cuts.