In addition to the obvious damage it does to upholstery and carpeting, floodwater is a corrosive and abrasive mixture of water and dirt that works its way into every seam and crevice of a vehicle. Sewage and chemical contaminants may also be present in floodwater, and in coastal areas salt water from ocean storm surges can increase the possibility of vehicle damage and costly auto repairs. Even if a car is mechanically safe to drive, sanitary concerns could make it unwise for you to do so.
Inspect the defects. To find the source of the defects, we perform a visual inspection as high as 24x magnification, use dye-penetrant inspection (DPI), or use fluorescent penetrant inspection (FPI). This allows us to find small pits, microscopic cracks and larger cracks in the gate. If these defects are not identified and repaired, more problems can arise for the gate and the mold.
How much drywall should you replace if you have drywall water damage? Generally speaking, if drywall has swelled or sagged 3/8 of an inch or more from the baseline, then you need to replace the entire sheet. Otherwise, you can cut out and water damage repair the water-stained portion. And remember to check the insulation behind the drywall for damage as well.
A critical part of any mold maintenance plan is to provide the technicians a historical summary of past issues and corrective actions so they may be aware of longstanding or unresolved issues during repairs. Unfortunately, some technicians skip this first stage until after they get a mold disassembled—and then they stop to research a problem whenever they see or feel something they don’t like.
When the next water damage call comes in for a flood cleanup due to a broken water pipe or drain backup, make sure you have all the commercial restoration equipment on hand that you need to tackle the job in a moment’s notice. Events like floods, hurricanes, wildfires and other natural disasters can leave homes and businesses in peril and in need of professional restoration services.
When a disaster of this magnitude occurs, the first things a plant will need are lighting and pumps. This requires the use of on-site generators and temporary power connections. It's highly recommended to not allow the plant distribution system to be back-fed. If a motor is required to turn a pump, a portable motor starter fed by the generator should be installed on a temporary panel next to the motor.
Accurate and efficient troubleshooting of past and current defects is based on a repair technician’s ability to understand and relate existing processing and production conditions (as revealed by tooling wear marks and residue characteristics) to historical data. Issues should be segregated (long gates, specific flash etc.), analyzed, and then corrected one at a time.
Regular cleaning may maintain household furniture’s upkeep but with Dallas Water Damage’s advanced cleaning technology, our technicians can fully restore your furniture in their brand new state while keeping them free from bacteria and viruses that may cause common health problems. Our competitive pricing options vary depending on your water damage and professional cleaning needs. You may call our 24 hour emergency call-in service for a free estimate today.
The electrical systems in modern cars are particularly prone to flood water damage. Engine control computers, vehicle sensors, infotainment systems, and other electronic devices – along with wiring harnesses and the many connectors that join them together – can be very difficult to salvage. Unless every part is thoroughly cleaned and dried, inside and out, problems caused by corrosion can crop up weeks or even months after the flooding.
Gone were helpful clues for the repair technicians who had yet to begin troubleshooting and analyzing mold performance and wear. So now, how will the repair techs determine if the 63-day production run was too long? Or whether the leader pins, bushings, and interlocks were greased properly during the run? And how will they know if all the swishing during cleaning did not create any “dings” in the sleeves that could be blamed on something else instead of poor cleaning practices? Other questions will remain unanswered, too: Does the mold still have excess vent residue in the top right quadrant? Were all the ejector sleeves numbered and in the proper mold position before they were removed?
Wanna keep things really cheap? Do it yourself! In some cases, minor mold problems (less than about 10 square feet of mold) in places like a bathroom corner can easily be handled by a handy homeowner with a free weekend afternoon and a few basic supplies from the hardware store. For more information, see our previous post on the subject: Do I need a Mold Remediation Professional?
Water damage is a serious problem that needs immediate attention fast. The faster water damage is treated, the more furniture and valuable items are saved from permanent damage. Water damage may happen at any time and the most common cause is flooding. Floods may be caused by natural disasters such as hurricanes and excessive rainfall. Sometimes flooding may occur due to leaking faucets, broken sewage pipes, and waste buildup under sink drains.
Believe it or not, there are three types of water. The first type is “clean” water from rain, condensation, leaky pipes, and so on. It’s relatively harmless to clean it up yourself. But if you decide to seek outside help, it costs around $3.75 per square foot for basic water damage cleanup (replacements not included). The second type is gray water, slightly dirty water from dishwashers, washing machines, clean toilets, and so on. And it may have some contaminants. But you can clean it up yourself if you remove it carefully and with proper safety gear to protect yourself. Professional water damage cleanup cost rises to $4.50 per square foot.
If you’re dealing with anything other than a large incursion, you understandably may be considering handling the cleanup and drying yourself to save money or time. The problem is that cleaning up and recovering from water damage isn’t always as straightforward as it seems. This post highlights 3 key things you need to be aware of when addressing water damage from a minor clean water (or Category 1) incursion.