A dark, damp crawl space allows mold to flourish, which can then cause structural damage. Moisture dripping through the concrete foundation of your home can cause basement leaks. Air leakage into the section between the attic and the home can cause moisture on the underside of the roof, which can lead to mold and rotting. Check your home periodically, and look for light fixtures that are look as well as the overall quality of any noticeable piping.

It’s time for one of the most important steps: removing any standing water from the home. The removal process is actually much less complicated than you may think. Contractors use fancy shop vacuums and rotate them around the room, sucking up all the water that’s present in the area. The amount of time this phase takes varies depending on the type of substrate that’s being dried, the size of the room and the total amount of water that’s present.
Mold: Some companies may allow you to purchase coverage for mold remediation. This varies from state to state and by insurance company. In some states like California and Texas, policy makers are pushing to have limited basic mold coverage added to the policies. However, the best way to find out if your policy provides any provision is to inquire with your representative or licensed insurance professional to find out if this could be available to you. It may be available by endorsement; every company is different.
The water restoration process is an important one. Using the right procedures and materials can help people save cherished belongings and even prevent their homes from being condemned. Water restoration companies specialize in mitigating the effects of water, but the success for water damage restoration depends on the severity of the damage and the amount of water that caused the damage. Water restoration companies may hire outside experts to assess a property and determine a water restoration and water removal plan. These water restoration companies typically use high-tech equipment and well-documented procedures to control water damage. Water in basement areas may only require a short cleanup process, but water in other areas of a property will require extensive remediation.

One of the simplest proactive steps is getting an annual plumbing inspection. These are often free or free with other services. The plumber will inspect all visible plumbing including fixtures, pipes, appliances, and drains. They diagnose and fix small problems before they become big ones. They can also tell you the best time to replace worn fixtures and appliances.


The insurance company will pay to repair your home with materials of like kind and quality to the original. For example, if the carpet was damaged, the insurance company will pay to replace the damaged carpet with carpet of a similar grade and quality. If you choose to upgrade the carpet or change the type of flooring, you will have to pay the extra costs yourself.
Public insurance adjusters are independent adjusters who help people negotiate claims with their insurance companies. Public adjusters work for you, not the insurance company. They charge you a fee for their services. The fee is usually a percentage of the claim and is subtracted from any settlement you get from your insurance company. You don't have to hire a public adjuster.
When a disaster of this magnitude occurs, the first things a plant will need are lighting and pumps. This requires the use of on-site generators and temporary power connections. It's highly recommended to not allow the plant distribution system to be back-fed. If a motor is required to turn a pump, a portable motor starter fed by the generator should be installed on a temporary panel next to the motor.
If the moisture damage has been neglected or gone unnoticed for long, you’re likely to find rot. Where possible, remove and replace soft, spongy studs and wall sheathing. Where removal is difficult, treat the affected areas with a wood preservative (available at home centers), after cleaning the wood and allowing it to dry. Then double up rotted members with pressure-treated wood.
Indoor and outdoor pipes and faucets. Routinely check indoor pipes under cabinets and sinks for leaks, rust, and any signs of deterioration. Minimize the potential for water damage from frozen and broken outdoor pipes by insulating supply lines (in attics, crawlspaces, and exterior walls), protecting exposed outdoor faucets, sealing gaps in exterior walls, and maintaining adequate heat in your home.

Remove all of the drywall from the wall if the wrong type of drywall was initially installed. On rare occasions, mold damage results from using the wrong type of drywall for a particular application. The two most common causes of mold damage, not created by water leaks, are drywall installed behind tile, or regular drywall installed in a bathroom instead of mold resistant drywall.

The information and advice contained in this article is intended as a general guide for informational purposes only. It does not take into account your personal situation. While we at Resolve have significant experience and history operating in the home restoration industry and working closely with construction contractors, we are not licensed as a general or specialty contractor. We encourage you to consider the information we’ve provided but urge you not to rely upon it in place of appropriate professional advice from a licensed, experienced construction contractor.    

If you have a high concentration of mold, you may smell it. If you detect the typical musty odor, check for mold on damp carpets, damp walls, damp crawlspaces and wet wood under your floors, wet roof sheathing and other damp areas. Clean up these infestations right away before they get worse, and see the following photos for prevention measures on how to remove mold.


If temperatures tend to freeze in your area, be sure to protect your pipes. Insulate both hot and cold water pipes using heat tape or pipe sleeves available in your home improvement store. If you have water supply lines in your garage, keep the garage door closed as often as possible. Open kitchen and bathroom cabinet doors to allow warmer air to circulate. If you plan to spend some time away from your home, leave the heat on and set your thermostat to at least 55 degrees. You can’t control the weather, but you can put up a good fight to save your pipes.
Steven Johnson worked as a toolmaker for 26 years, rebuilding and repairing multicavity molds for Calmar Inc. and then as mold-maintenance engineer for Hospira Inc., a medical device manufacturer. Today, he is the maintenance systems manager for Progressive Components and has his own business, MoldTrax in Ashland, Ohio, which designs and sells software for managing mold maintenance (www.moldtrax.com). He can be reached at [email protected] or (419) 289-0281. 
The project documentation manager should make sure the camera memory sticks are downloaded to a folder located on the site server. Each picture will be opened and saved in a folder labeled by the appropriate power center or room number. There are two pictures associated with each piece of equipment, both of which should be labeled using the sequence number. After saving the pictures on the local server, the memory sticks will be erased and ready for use the next day.
Ceilings exposed to water damage are more at risk due to gravity: You don’t want them sagging or collapsing. So, remove affected ceiling panels or boards first. If the ceiling leak is caused by a roof problem, it’s important to find the true source of the leak, which may be somewhere far removed from the water stain. And take this time to make sure the water caused no structural damage to beams or rafters. You can contact professionals to find out what replacing a water damaged ceiling repair cost job runs.
Water damage is a problem that most property owners dread. When it rains heavily or snow melts quickly, the risk of this type of damage increases. Water can cause thousands of dollars’ worth of damage by damaging wood furniture, upholstery, electronics, household appliances, and plumbing equipment. Water damage also increases the risk of mold growth, which is a very expensive problem to remediate. Hiring a water damage restoration company can make the cleanup process easier to handle, as these companies employ experienced workers who know the best ways to repair or replace damaged items and help with water damage cleanup.
While you have no control over natural water-related disasters, you can take all the preventative measures possible ahead of time to minimize their effect on your home. Flash floods, sudden storms and hurricanes can all trigger water buildup. Prompt attention by contacting The Water Damage Experts as soon as you can after a weather-related issue will help lessen the time for water damage to occur.
We are an emergency water damage company that provides service to all residential and commercial water damage victims throughout Hillsboro. If you have flooding of any kind, our professionally trained and certified experts can rapidly and effectively solve the problem on short notice. We not only fix the original problem, but we make sure that any affected area is professionally cleaned, deodorized and sanitized. Our experts are available to handle any crisis 24 hours a day. Don’t hesitate, call us today!
When water invades your home, it can be an overwhelming and stressful experience. When this happens, the best course of action you can take is to call a restoration company, such as Mr. Restore, immediately. As soon as we arrive on your property, our team can find the source of the problem, stop the water from coming in, and proceed with the water removal process. If you wait on contacting us, secondary water damage can occur, and mold formation could potentially begin. Our crew thoroughly dries any surfaces that have incurred water damage, such as wood, drywall and paneling.

Air movers help to ventilate the affected area, circulate air so that the moisture can be extracted by dehumidifiers and dry damp materials such as drywall and floors. There are a number of different types of restoration air movers and the best choice for you will depend on the planned application of the equipment. The ideal equipment should have the perfect balance of horse power and amp draw. 
×