Roofs should be inspected annually. A professional roof contractor can look for exterior and interior warning signs that your roof’s condition may lead to water damage, including cracked or missing shingles and areas where water is prone to pool. An inspection can cost several hundred dollars, but in exchange for your peace of mind, it’s priceless.
Surface molds grow in just about any damp location, such as the grout lines of a ceramic tiled shower. They’re easy to scrub away with a mold cleaner mixture of 1/2 cup bleach, 1 qt. water and a little detergent. In mold remediation, the bleach in the cleaning mixture kills the mold, and the detergent helps lift it off the surface so you can rinse it away so it won’t return as fast. You can also buy a mildew cleaner at hardware stores, paint stores and most home centers.
Locate and repair the source of the leak. The source of the problem is usually apparent once you remove the drywall and expose the framing. If the leak source is not easily determined, consult a licensed contractor before you replace the drywall. You must repair the cause of the leak or mold and mildew will eventually reform over the new drywall. An unresolved leak may also create additional damage to framing, insulation, siding and flooring.
The resulting damage is a different than the initial damage.For example, if water damage resulting from a broken pipe, or appliance is listed in your wording as covered, then you may be compensated for a portion of the damages caused even though the deteriorated pipe replacement or a new appliance would not be covered. This is an example the cause of the damage not being covered, but the resulting damage being covered.

"Using truck-mounted vacuums with 2,000 horsepower, and dehumidifiers, we can extract moisture from furniture, hardwood, tile, even Sheetrock," Kent says. Even electronics like TVs and laptops may still operate after a thorough drying. "In fact, when carpet gets wet, people think it's ruined, but it actually ends up stronger than when it was made," Kent says.
Roofs. Keep roofs free of debris that can damage roofing and allow water to seep in. Trim tree branches to prevent them from rubbing and damaging the roof. Repair missing or damaged shingles. Properly seal any cracks around chimneys, skylights, and vents. Check metal flashing for holes, cracks, or other damage. Replace flashing or use silicone caulk to seal any openings.

The electrical systems in modern cars are particularly prone to flood water damage. Engine control computers, vehicle sensors, infotainment systems, and other electronic devices – along with wiring harnesses and the many connectors that join them together – can be very difficult to salvage. Unless every part is thoroughly cleaned and dried, inside and out, problems caused by corrosion can crop up weeks or even months after the flooding.
Black water contains pathogenic agents and is grossly unsanitary. Anyone with a compromised immune system, respiratory problems, or allergies, as well as young children and the elderly must remain off the job site until the building is judged safe for occupancy. Black water includes sewage and other contaminated water sources entering or affecting the indoor environment, such as: toilet backflows, flooding from seawater, ground surface water, and rising river water. Category 3 water can contain contaminants such as pesticides, heavy metals, or toxic substances.
Among the most common and most preventable causes of water damage are burst pipes. Burst pipes typically happen because of clogs and freezing. Prevent the damage by finding a family plumber to do annual inspections. Regular inspections and maintenance are a cost-effective, preventative measure. Installing new plumbing typically runs between $350 to $2,000.
Whatever the mess, whether you discovered flooding from a broken or leaky pipe, damage from frozen pipes, a sewer line break, a sink or toilet overflow, or a malfunctioning appliance like a water heater, washing machine, dishwasher or refrigerator in your home, or you’re a victim of storm damage, our Hillsboro flood damage technicians are equipped to handle any problem. WaterBear is here for all water cleanup and restore your home or business back to normal, quickly and right the first time. Acting fast against flood damage can increase the chance of salvaging usable materials, reducing costs, and saving time, so we guarantee a fast response and professional guidance to help you sort out the options, work with your insurance agent and get flood cleanup and restoration underway.

In the event of water damage, Mr. Restore is the company to call in Dallas. Not only do we offer 24/7 emergency services, but we are also on site within the hour. Our complete restoration services include advanced drying technologies. Our project managers are certified through the American Drying Institute and can ensure that the damage is little to none. We are family owned and operated in Dallas and offer free evaluations to those who contact us for restoration service or environmental remediation. We pride ourselves on being a total restoration and cleanup company. We handle all of our projects in with the highest level of expertise and experience.

A dark, damp crawl space allows mold to flourish, which can then cause structural damage. Moisture dripping through the concrete foundation of your home can cause basement leaks. Air leakage into the section between the attic and the home can cause moisture on the underside of the roof, which can lead to mold and rotting. Check your home periodically, and look for light fixtures that are look as well as the overall quality of any noticeable piping.
Once our restoration team removes the moisture from your home or business, we then will begin repairing and restoring the property. The length of this process depends on the extent of damage. Our team of trained technicians uses all the latest technology and top industrial equipment to remove the moisture and prevent further damage. The sooner that we are contacted, the less damage can affect your property. We offer emergency services and can arrive at your home or business almost immediately. Call Mr. Restore in Dallas today for a free evaluation of the services we provide.
When a severe thunderstorm hits, the risk for property damage increases greatly as heavy rains can cause water damage as well as flooding in your home.  Flooding from storms is a major problem that requires a combination of methods to correctly treat it and protect your health.  Unlike typical water damage from a leaky roof or a burst pipe, flood damage often includes raw sewage that can complicate the remediation process.  As soon as flooding occurs in your home, make sure to call a flood damage cleanup expert to mitigate the damage and safely remove the flood water.
If temperatures tend to freeze in your area, be sure to protect your pipes. Insulate both hot and cold water pipes using heat tape or pipe sleeves available in your home improvement store. If you have water supply lines in your garage, keep the garage door closed as often as possible. Open kitchen and bathroom cabinet doors to allow warmer air to circulate. If you plan to spend some time away from your home, leave the heat on and set your thermostat to at least 55 degrees. You can’t control the weather, but you can put up a good fight to save your pipes.
If you repair damage resulting from an appliance-related leak, you need to get a Certificate of Appliance-Related Water Damage Remediation (WDR-1). The certificate verifies that the damage was properly replaced or repaired and that any related physical damage was properly remediated, repaired, or replaced. If you don't have the repairs or remediation certified by a WDR-1, an insurance company can deny you coverage in the future based on previous appliance-related damage or claims.
Once you get the OK from your insurer to remove the water, use a sump pump, available from most hardware or home supply stores for $150 to $500, and a wet vac ($40 to $130). Ramirez cautions that water is heavy—a cubic foot weight 10 lbs.—so be careful not to injure yourself, especially if you’re carrying buckets of water up and down stairs. Open doors and windows to allow fresh air to circulate so long as that won’t allow in more water. 
Mark the damaged drywall with a pencil after you determine the area of drywall you want to remove. Use a straightedge to mark lines vertically and horizontally on the face of the drywall. Whenever possible, have the lines fall over the centers of the framing members behind the drywall; this will provide backing and a fastening surface for the drywall patch.

Among the most common and most preventable causes of water damage are burst pipes. Burst pipes typically happen because of clogs and freezing. Prevent the damage by finding a family plumber to do annual inspections. Regular inspections and maintenance are a cost-effective, preventative measure. Installing new plumbing typically runs between $350 to $2,000.
The resulting damage is a different than the initial damage.For example, if water damage resulting from a broken pipe, or appliance is listed in your wording as covered, then you may be compensated for a portion of the damages caused even though the deteriorated pipe replacement or a new appliance would not be covered. This is an example the cause of the damage not being covered, but the resulting damage being covered.

How to remove mold and how to perform black mold removal can be done with ordinary household cleaning products. But disturbing big infestations of mold on bathroom walls and other places can be bad for your health, particularly if you are an allergy sufferer or have a weakened immune system. When you discover an extensive mold problem, we recommend that you use the rigorous protective measures we show in Photos 1 – 6, or consider calling in a professional, who knows what kills mold, to handle the problem of how to remove mold. (Search “Industrial Hygiene Consultants” or “Environmental and Ecological Consultants” online to find out how to remove black mold and black mold removal cost. Or call your local public health department on how to get rid of black mold.) And even if you hire pros, read through this article and make sure they follow similar precautions on how to get rid of mold and to keep the mold from spreading throughout your house.
Appliance hoses. Broken hoses are among the most common causes of water damage. Regularly inspect hoses and hose fittings on washing machines, icemakers, and dishwashers for kinks, cracks, bulges, or deterioration. Replace standard rubber washing machine hoses every two to five years or more often if they are showing signs of wear. Consider using steel-reinforced hoses for longer life.
Once our restoration team removes the moisture from your home or business, we then will begin repairing and restoring the property. The length of this process depends on the extent of damage. Our team of trained technicians uses all the latest technology and top industrial equipment to remove the moisture and prevent further damage. The sooner that we are contacted, the less damage can affect your property. We offer emergency services and can arrive at your home or business almost immediately. Call Mr. Restore in Dallas today for a free evaluation of the services we provide.
Water damage is a problem that most property owners dread. When it rains heavily or snow melts quickly, the risk of this type of damage increases. Water can cause thousands of dollars’ worth of damage by damaging wood furniture, upholstery, electronics, household appliances, and plumbing equipment. Water damage also increases the risk of mold growth, which is a very expensive problem to remediate. Hiring a water damage restoration company can make the cleanup process easier to handle, as these companies employ experienced workers who know the best ways to repair or replace damaged items and help with water damage cleanup.
You may also wish to hire a flood restoration service—you can find pros under “Flood” or “Disaster recovery” in your local phone book, or check with the Better Business Bureau, local Chamber of Commerce, or contractor recommendation sites, such as Angieslist.com or MerchantCircle.com. Look for those with Institute of Inspection, Cleaning, and Restoration Certification.

Pipes that burst or leak are common culprits of water damage. Drains and toilets that get backed up and blocked can cause undue pressure in the pipe, which then causes it to burst or leak. Garbage disposals that aren’t working properly are another common reason for pipes to burst, as are roots that grow in the yard into the sewer lines. Old or rusty pipes are also more prone to leaking.
Mark the damaged drywall with a pencil after you determine the area of drywall you want to remove. Use a straightedge to mark lines vertically and horizontally on the face of the drywall. Whenever possible, have the lines fall over the centers of the framing members behind the drywall; this will provide backing and a fastening surface for the drywall patch.
In addition, it’s important to have a working flashlight and turn off all water and electrical sources within the home, says Dr. Maurice A. Ramirez, author of “The Complete Idiot’s Guide to Disaster Preparedness.” Even if the power isn’t operational, it’s a good idea to go to your fuse box and turn off the main, plus all of the individual fuse connections. That way, if the power is reactivated, you’re not at risk for mixing standing water and electricity.
For instance, it will be less expensive to restore a basement with an inch of clean water from a burst pipe than to tackle a fix caused by three feet of sewage backup. An inch of clean water would start at around $500 to $1500 to pump out and thoroughly dry it. However, the price of basement drainage repairs can increase up to $10,000 or more depending on the size of the space and the extent of the damage. Budget more when your space has been hit from contaminated sources, like a river flood.
Our technicians are certified by the Institute of Inspection, Cleaning and Restoration Certification (IICRC), which is the hallmark of professional knowledge in the cleaning and restoration industry. You will be able to tell the difference: Rainbow International emergency water damage crews use state-of-the-art equipment and we employ Rapid Structural Drying techniques to dry your structure as quickly and completely as possible.
Once you discover moisture, your first instinct may be to open windows to help with the drying process, but it may not be your best move. For example, if your building is mechanically ventilated, the systems need constant pressure levels to work correctly. You also want to avoid excess coolness or heat and humidity, or you may end up complicating the drying process.
×