After a mold has been cleaned, repaired, changed over, and final-checked, it needs to be given a new status and moved to one of three areas—typically racked in holding/storage area, reset in the press, or staged as a back-up mold in a molding-cell operation. It could also go to an outside vender for rebuild or production. You should know where your molds are.

Your insurance company will only pay for additional living expenses up to your policy's ALE dollar limits. Because repairs on your home can sometimes take months, monitor your expenses carefully to make sure you have enough ALE to cover the entire time you’ll be out of your home. If you reach your policy's ALE dollar limits before your home is fully repaired, you’ll have to pay the rest of the expenses out of your own pocket.
Ice dams and other roof problems can also cause water damage to siding materials as well. Here, the biggest danger is water seeping in behind your siding and causing permanent damage to more vulnerable materials. So if this happens, you will need to remove or replace the siding quickly before rot sets in. Water can also seep in behind faux stone and other external walls around your home. So it’s important to be thorough in this inspection.
Most of us are very familiar with lockout/tagout procedures, test-before-touch practices, and applying safety grounds. While these are key safety aspects of putting equipment into an electrically safe condition, there are other safety items that need to be addressed when working in a natural disaster area. Items such as air quality, structural issues, and chemical spill exposure come into play. It is the responsibility of each company to keep its own people safe and supply them with special personal protective equipment (PPE), such as rubber boots, respirators, dust masks, portable gas monitors, and rubber gloves. As a service company, you must also coordinate with plant safety personnel you've contracted with to develop special safety procedures to address the ever-changing site conditions. Frequent safety meetings are a must to keep everyone up to date with the most current hazard conditions on the site.
This information is not intended as an offer to sell, or the solicitation of an offer to buy, a franchise. It is for information purposes only. Currently, the following states regulate the offer and sale of franchises: California, Hawaii, Illinois, Indiana, Maryland, Michigan, Minnesota, New York, North Dakota, Oregon, Rhode Island, South Dakota, Virginia, Washington, and Wisconsin. If you are a resident of or want to locate a franchise in one of these states, we will not offer you a franchise unless and until we have complied with applicable pre-sale registration and disclosure requirements in your state.
Gray water contains a significant level of contamination and has the potential to cause discomfort or sickness if consumed by or exposed to humans. Gray water may contain chemicals, bio-contaminants (fungal, bacterial, viral, algae), or other contaminants. Examples include: discharge from dishwashers or washing machines, overflows from washing machines, overflows from toilet bowls with some urine (no feces), sump pump failures, seepage due to hydrostatic pressure, broken aquariums, and punctured water beds. Gray water that remains untreated for longer than 48 hours may escalate to Category 3.

Water damage is a serious problem that needs immediate attention fast. The faster water damage is treated, the more furniture and valuable items are saved from permanent damage. Water damage may happen at any time and the most common cause is flooding. Floods may be caused by natural disasters such as hurricanes and excessive rainfall. Sometimes flooding may occur due to leaking faucets, broken sewage pipes, and waste buildup under sink drains.

Inspect the defects. To find the source of the defects, we perform a visual inspection as high as 24x magnification, use dye-penetrant inspection (DPI), or use fluorescent penetrant inspection (FPI). This allows us to find small pits, microscopic cracks and larger cracks in the gate. If these defects are not identified and repaired, more problems can arise for the gate and the mold.

The longer water damage sits untreated, the more likely it is that additional damage can occur. If it’s determined that drying equipment is needed, dehumidifiers will often be placed in the home to prevent against further damage like mold growth while the vendor is waiting for approval from the insurance company, if one is involved. Dehumidifiers can be present for one or multiple nights depending on factors such as the length of time the water has been present and the source of the leak. The contractor working on your home will be able to assess how long the dehumidifiers are needed.
If temperatures tend to freeze in your area, be sure to protect your pipes. Insulate both hot and cold water pipes using heat tape or pipe sleeves available in your home improvement store. If you have water supply lines in your garage, keep the garage door closed as often as possible. Open kitchen and bathroom cabinet doors to allow warmer air to circulate. If you plan to spend some time away from your home, leave the heat on and set your thermostat to at least 55 degrees. You can’t control the weather, but you can put up a good fight to save your pipes.
In the United States, those individuals who are affected by widescale flooding may have the ability to apply for government and FEMA grants through the Individual Assistance program.[1] On a larger level, businesses, cities, and communities can apply to the FEMA Public Assistance program for funds to assist after a large flood. For example, the city of Fond du Lac Wisconsin received $1.2 million FEMA grant after flooding in June 2008. The program allows the city to purchase the water damaged properties, demolish the structures, and turn the properties into public green space.[2]
×